Large Feather Plucker SV-65

$902.85
SKU:
SP -973
Weight:
120.00 KGS
Shipping:
Calculated at Checkout
Plucker 65

THIS IS OUR SECONG LARGEST SIZE  PLUCKER

MADE FOR CHICKENS,DUCKS,GEESE,AND TURKEYS.  YOU GENERALLY HAVE TO ADD DOWNY TO THE SCALDING WATER FOR WATER FOWL.

IT WILL DO  5 - 8  CHICKENS AT ONCE DEPENDING ON SIZE.  I HAVE DONE A 25 POUND TURKEY.

 IT DOES A GREAT JOB PEALING POTATOES AND OTHER VEGETABLES. EVEN SCALING FISH.

LET`S JUST SAY IT IS LARGE.  FOR LARGER YOU NEED THE  SV-80

 

SHIPPING. 

DUE TO WEIGHT WE SHIP FREE BY TRANSPORT TO A DEPOT NEAR YOU.  YOU CAN PICK IT UP IN OUR STORE.

                                       

WARRANTED     OUR STANDARD COMPANY WARRANTY.   SEE WARRANTY BOTTOM OF HOME PAGE

SPECIFICATIONS

ELECTRIC POWER  ........... 3,00 WATTS  110 VOLTS  Requires a 30 amp breaker.

PACKED SIZE         ...........   104 W - 78 D  - 95  H  CM.

WEIGHT                 ...........   120 KG.

NUMBER FINGERS     .......  162

MATERIAL             ...........   STAINLESS STEAL and  ALUMINUM WITH A METAL PAINTED FRAME.

ROTATION SPEED   .........   245 RPM

DRUM DIAMETER   ..........   72.5 CM

Plucking Method

1. Scald the poultry after slaughtering. Temperature 65-80 degree Celsius.

 2. Then turn on the machine. Place the scalded poultry into the machine.  One at a time until you see slowing down or birds piling up. Do not overload.

 3. After 10 seconds turn on the tap,and wash away the removed feathers, then stop the machine, and remove the bird.

 4. The whole process is less than a minute.

 5. It takes a few runs to get your scalding right.  I use a digital lazer thermometer available on our site or from Home depot. This takes the guess work out.

 NOTE     This unit will scale fish and peel potatoes very well. 

 SAFETY Attention read below.

 1. Make sure you use a three prong plug. Grounding is very important as you are using water and a metal appliance. 

 2. Turn on the switch and make sure the machine is running normally before using.

 3. Wash the tub completely after using.

 4. Change the  fingers when they are wore or broken. Keep the efficiency up and eliminate   vibration.

 5.  Belt slippage happens when you overload or when the belts are worn or to lose.

 6.  Adjust the tension on the motor base, but note it can't be too tight as this can damage the motor if it stalls out. Keep it just where there is no slippage. You may hear a squeal and this means it is to lose.